Close the Print Window and Open Again
Have you lot reinstalled the printer since the last upgrade?
-----------
If this answers your question - Then mark it so. Then others may find it.
---------------
Effectually computers
since 1952
lacrumb
11 people found this respond helpful
·
Was this reply helpful?
Hi George,
My proper noun is Lee and I'thousand sorry for the inconvenience.
•To enable Printer Spooler, press Windows + R and blazon services.msc
• Locate the Impress Spooler service
• Showtime this service if information technology'south stopped, if information technology's already running, attempt to Restart
If my proposition did non solve the event, please answer back and so we can effort other step.
Kind Regards,
< / L e due east >
10 people found this reply helpful
·
Was this reply helpful?
My print spooler will not continue to run even after numerous starts and restarts. I have even hit stop and did starts and restarts. I checked the continencies and they are all running. It is print spooler itself. Later I get-go or restart it runs for a short while and and so stops. It is set for automatic start upon computer start but will not stay running. Cannot impress or install whatsoever printers. Suggestions on getting the impress spooler corrected?
2 people plant this reply helpful
·
Was this respond helpful?
i Accept started experiencing the exact aforementioned problems today. The print spooler will not stay on. it lets me print one time, so turns itself off again
2 people found this reply helpful
·
Was this reply helpful?
I took computer to Figurer Repair and they couldn't become information technology working either. They suggested resetting the computer, which I did. It works fine now. Just make sure to relieve personal files because it wipes everything clean and goes back to manufacturing plant setting. Good luck.
Was this reply helpful?
Thank you for the information. I was hoping for a simpler solution, without having to wipe the computer make clean.
Was this reply helpful?
I did what you kindly suggested. It was running. I did press restart. It didn't process very long. It was however running when I left the page. Whatsoever other suggestions. I have tried everything and am quite baffled. thanks MaryAnn
1 person found this reply helpful
·
Was this reply helpful?
I had to completely reinstall the operating arrangement to mill setting. Be sure to backup all your files. Took a little time but not every bit much as I spent over five days trying to get a restart or offset to continue. This was recommended set by calculator repair service later they couldn't get it to proceed running after restarts.
Was this reply helpful?
My spooler is running, that was not my problem. Odd though, everything was fine then of a sudden I could no longer print annihilation and I have also spent as well many hours trying to fix it. Troubleshooting tells me that everything is AOK. Plus my printer is NOT off-line., looked into that likewise. Frustrating. Thanks for trying to aid
MaryAnn
Was this respond helpful?
My printer won't print. I've run the troubleshooter and it tells me that I demand to open the impress spooler. I don't know how to open up the print spooler. I need some help.
Was this reply helpful?
Source: https://answers.microsoft.com/en-us/windows/forum/all/how-do-i-start-the-print-spooler-in-windows-10/d71b219e-1a36-4ea1-9d07-f511772e6b6e
0 Response to "Close the Print Window and Open Again"
Publicar un comentario